| Search | Login/Register
   Home » Horn-Loaded Speakers» "Something is rotten in the state of Denmark". (2 posts, 1 page)
  Print Thread | 1st Post |  
Page 1 of 1 (2 items) Select Pages: 
12-12-2014 Post does not mapped to Knowledge Tree
Romy the Cat

Boston, MA
Posts 9,966
Joined on 05-27-2004

Post #: 1
Post ID: 21393
Reply to: 21393
"Something is rotten in the state of Denmark".
Unquestionably it is a very interesting landscape project:
…however from audio perspective it does raise a very interesting question. As you can see the mouth of that exponential horn has holes. For sure they did it to save material and ease the mass of the horns but it also might be a VERY interesting solution for LF only horn. It is known that exponential profile if used for lower octave produced very characteristic sound. The best remedy is to randomize the leading edge of the horn output with "confusing reflections". However here is where the Denmark folks unknowingly (because for wrong reasons) proposes to do something differently: to introduce the LF leaks in the horn and let some sound to be "shorted" at the exit of the horn. I think the proper "shorting" need to be done by radial sluts and perhaps to be adjustable (sluts might be closed). So to test it we would need to make lest say 100Hz exponential ½ horn and to permit it to have open-able sluts. It is possible, juts possible that this horn will have "gentle entry" into the room and will not sound like most of the exponential bass solution out there.
Tha Cat

"I wish I could score everything for horns." - Richard Wagner. "Our writing equipment takes part in the forming of our thoughts." - Friedrich Nietzsche
12-12-2014 Post does not mapped to Knowledge Tree
Paul S
San Diego, California, USA
Posts 2,407
Joined on 10-12-2006

Post #: 2
Post ID: 21394
Reply to: 21393
Horns and Loose Women
Are those photos, or "renderings"? If the former, and that project actually exists, someone put up a LOT of money for it!

With respect to the "sluts", the blurb tells that the holes in the horns make different sounds that relate to the "elements". So, would slots in a smaller horn do the same and, if so, could these sounds be "tailored"? I hope someone will try it out.

Paul S
Page 1 of 1 (2 items) Select Pages: 
Home Page  |  Last 24Hours  | Search  |  SiteMap  | Questions or Problems | Copyright Note
The content of all messages within the Forums Copyright © by authors of the posts