|
|
| Romy the Cat's
personal site dedicated to advanced audio and evolved music reproduction
techniques
|
|
 |
|
|
|
|
|
[quote user="morricab"] The one thing that the Lamm ML2 does differently than nearly all tube amps is regulation of the output stage. They do this with the 2nd 6C33C that is on the chassis. Even the KR amps don't do this and I think it is...
|
|
Yeah, so the closeness of the grids results in a higher current gain. So what? What is the relationship between gain and sonics? Are you saying that all high gm tubes sound better than low gm tubes? And does that include 300B ...
|
|
Romy,Nah, I just want to careful with what I have left, dont want to have an amp without tube for now. The gold grid tube probably take a while to get them. From what I remember from a tube dealer who said that these 6C33C need to have the heater bur...
|
|
[quote user="hagtech"]I have not tried this tube yet. It might push the limits of the tester. The 6.3V heater current supply is nominally rated at 5 amps. It might be ok to push it to 6.6 amps. I have to think about this, make...
|
|
[quote user="hagtech"]Note the '63 has much higher gain. The horizontal spacing is basically "mu". Interestingly, the 6e6p has lower gain than both of these. To me, the curves are beautiful. Spacing is relatively constant, ind...
|
|
[quote user="KOTriode"]Romy,I have good confidence that it was the tubes and not the circuit. I have checked the cathode driver that bias the 6C33C and there was not any problem. Sure if the cathode bias failed, the 6C33C current will shoot way u...
|
|
Jim, I do not know what to say: I never experienced any nose problem with it. A few years ago I built 2 mono phonocorrectors with 7788 at input as a pentode both of them were just nice and quiet and did not give me any problems in noise department. T...
|
|
finally these beautiful pre/power delivered to me and they are playing music for break-in.I will report about sound of Audiopax model 5 & Model 88.The system : CEC TL0 3.0 Transport Audio Note DAC 5 Special Audiopax model 5 Audiopa...
|
|
With this tube I would think cathode emission limits lifetime. Stepping back a moment, I'm guessing this tube is designed for radar operation. Maybe in an aircraft. The spec sheet definately talks only about pulse mode of opera...
|
|
Hm, it is interesting. The loud popping pings in the lower MF and upper bass region are unmistakably signs of the 6C33C be gunner. Then you replaced the tube and the pings are still there. It is very highly unlikely. You might burn a cap that interm...
|
|
Hi Romy,I am very interested in what you have found out about the 6C33C tube lifetime because I am using a pair of Silvaweld OTL tube reference (their name for them not mine) amps that use 4 x 6C33C-b tubes per monoblock (so a total of 8). Thes...
|
|
Celsius, I do not know what CCS you impended, did you drive 6e5p’s plate with constant current source? I also do not know/like 6e5p with battery bias. The only application that I find 6e5p suitable was the Milq-style bias with two gas tube driving ...
|
|
Totally disappointed today, while I was listening to music, the left channel make a small pop and quit. The bias meter showed about 25ma bias instead of 200ma. Test the tube on bench showed that the tube current stay about 25-50ma max. This tube is g...
|
|
Something that has long puzzled me is that circuit designers seem ever determined to wring the last ounce of gain from every tube in a given circuit, or they will "starve" them, and the circuit in turn is designed as if it were simply a mathematical ...
|
|
Thank you for the comment on this amp, this is my first time of using the 6C33C tube, I decided to build this amp after reading about the Melquiades, this amp is just a quick experiment on the 6C33C sound, since I have...
|
|
The preamp has the classic tube regulated power supply using 5R4, 6AS7, 6SJ7. It is transformer coupled output and has no capacitor in the signal chain, the gain is about 8db, so it is not a buffer. For convenience, it does has a remote control. It i...
|
|
[quote user="guy sergeant"]The load lines are horrible. I can't imagine it gives a very accurate representation of what is fed into it. Maybe that's not what you are after.[/quote]It is not that I completely agree (or completely understand) the Eduar...
|
|
Sadly I have never spent the time to try and correlate the sonics of a tube with the trace characteristics. Ok, sometimes it is obvious. A flat line is a dead tube. Normally I measure and compare both sections of dual triodes. ...
|
|
I do not know here to start. I absolutely assertively insist that under normal circumstances it is absolutely imposable to buy matched pairs of NOS tubes, particularly the high Mu tubes. When sellers advertised the “matched pairs” I just discard the ...
|
|
[quote user="Romy the Cat"]I have to admit that I have written a few pieces of writing about my experiences with YO186 but I withhold to post it as I do not know if it might valuable for anybody. It looks like no one use YO186 on West. There are ...
|
|
Just thinking about it, it seems that in order for the sealant (silicone?) to adhere to the inner wall of the tube, the sealant would have to be applied to a tube that has not been in contact with the damping fluid, especially if that fluid is petrol...
|
|
[quote user="N-set"]Risking that the topic has already been discussed and that I postin a wrong category (Romy feel free to (re)move this post:Is there any sense in trying 6C33 at higher volatges and lower currents?More precisely, I've been wondering...
|
|
The name of the post I took from the 32th chapter of M. Bulgakov’s Master and Margarita, so from there will be the epigraph for this post:
“Gods, my gods! How sad the earth is at evening! How mysterious are the fogs over the swamps! …So...
|
|
[quote user="Paul S"]While you are merely being empirical, there are actually plenty of devices that aim to "benefit" the end sound of SS gain by using tubes to "condition" the signal from DACs, etc. Also, there are plenty of commercial widgets ...
|
|
[quote user="Romy the Cat"]
Reading at my site Paul’s narrative about his fight with ML2’s tube and the ML2’s tube sockets I need to confess that I always was suspecting that he is some kind of odd wacko with bizarre and sick approach to the subject...
|
|
I do not know, you have to decide to yourself what kind tubes and the most important HOW you would like to test them. For different tubes, differently used the different things are important. I had a few testers and all of them were OK but all ...
|
|
Perhaps you are right. Buying out tubes from manufacture is a secure way to go. Still, I abandoned this practice in 2002 when Lamm sold me a pair of 12AX3 for his L2. When I got them one of the tubes was with paces of metal riddling inside. I figure ...
|
|
[quote user="unicon"] Roman, It is interesting to see you using your pipe in room.You mentioned its wrong to use them as LF consumer. You got it somehow wrong1-sealed tube traps can absorb LF and yet again absorb all HF in the same time...2- the ...
|
|
[quote user="rafaroxlm"]As you may know the 7788 is a high transconductance pentode which should in theory be able to give higher audio resolution than say 12AX7, 6072 tubes in tube mic pre designs. On search here the 7788 was mention...
|
|
[quote user="KOTriode"] The Melquiades give me inspiration to build this 6C33C amplifier. It's on a stereo chassis that has few unique features - Vacuum tube rectifier separately for Input/Driver and Output tubes. - Regulator using the same tube ...
|
|
|
|
|
All context of this site except the Forum's posts
Copyright © Roman Bessnow 2004-2024
All messages within the Site’s Forum Copyright © by
authors of the posts
|
|
Last 24-hours posts: |
0 |
|
 |
|
|
Total human visitors: |
42,823,252 |
|
|
|
|
|
|